Avatar
Finex

0 Following 0 Followers
1
StackyPi is a small and powerful board that has the RP2040 microcontroller and one set of 2x20 pin headers for connecting Raspberry Pi HATs. It implies that a Raspberry Pi HAT may be plugged in and operated on the StackyPi, allowing the user to execute additional operations.
1
The 8-bit level shifter is an 8-bit non-inverting shifter breakout board with the TXB0108 IC and VCCA Voltage Range: 1.2V-3.6V and VCCB Voltage Range: 1.65V-5.5V that functions as a bridge between applications with different source voltage and input-output voltage levels. Using an 8-bit level shifter with a short propagation delay and a wide supply voltage range can increase the efficiency of your job.
1
1.14 Inch LCD Breakout is a 1.14-inch display breakout with a resolution of 240 x 135 pixels, 65K RGB colours, and a crisp and colourful showing effect, built specifically for cross-platform to broaden its involvement via SPI communication by including a GPIO header, and built specifically for cross-platform to broaden its involvement via SPI communication by including a GPIO header. The 1.14 Inch LCD Breakout includes the ST7789 Driver and SPI Interface, decreasing the amount of IO pins required.
1
1.14 Inch LCD Breakout is a 1.14-inch display breakout with a resolution of 240 x 135 pixels, 65K RGB colours, and a crisp and colourful showing effect, built specifically for cross-platform to broaden its involvement via SPI communication by including a GPIO header, and built specifically for cross-platform to broaden its involvement via SPI communication by including a GPIO header. The 1.14 Inch LCD Breakout includes the ST7789 Driver and SPI Interface, decreasing the amount of IO pins required.
1
The number 1.28 "The Round LCD Breakout is a 1.28-inch display breakout with 240 x 240 resolution, 65K RGB colours, and a crisp and colourful showing effect. It is designed to assist gadgets enhance their interaction through SPI by offering a GPIO header for convenient interface. The 1.28 incorporates the GC9A01 display driver and SPI interface "The number of IO pins required is reduced by using a round LCD Breakout.
1
PiTraffic is a low-cost Raspberry Pi HAT that connects users to the real-world traffic signal system. The programmable buzzer and buttons are linked directly to the GPIO Port and work on a 5V input. It's a series of four traffic lights with bright LEDs (Red, Green and Yellow).
1
With the display driver SSD1306, this 0.91 inch 12832 OLED Display Module has a resolution of 12832 pixels. It has a much smaller footprint and is thinner than LCD screens with comparable brightness. It's made to create more accurate and vibrant colours.
1
With photo-coupling isolation on a load of 250V AC/7 A, 30V DC/10 A, and a trigger voltage of 3.3 V, the PiRelay 6 relay shield can control up to 6 appliances/devices. It assists the user in enhancing the gadgets' intelligence.